What is the cause of diamond saw blade bouncing

Jun 11, 2023

External causes of diamond saw blade edge breakage:

1) During long-term operation, sound listening machines will produce resonance. It is well known that cars will produce resonance, and saw blades will vibrate or shake during operation. If the vibration with the machine is too large, the contact area with the ground can be adjusted; If the saw blade shakes excessively, the contact surface between the transmission shaft and the machine can be adjusted, resulting in the transmission of vibration. So when listening to the sound, if the machine is operating normally, there will be no harsh cutting sound.

2) The service life of bearings. Nowadays, most domestic machines use sealed imported bearings. Sometimes, during long-term operation of the machine, the bearings are damaged due to vibration or dust (because the bearings are sealed and do not require maintenance) or the wear of the rubber circlips outside the fixed bearings. Viewing method: It can be determined by listening to the sound at the beginning or end of the machine

3) The shaft has a certain degree of curvature during use. Including the groove saw, which has been calibrated at the factory, that is, the two ends are aligned in a straight line. If there is an edge explosion and the adjustment cannot be adjusted at the factory, it indicates that there may be a problem with the shaft. If there is a problem in the use of engineering, what is the cause of it? Usually, workers do not understand the direction of the up and down saw blades when disassembling them, or do not remove the main saw hexagonal wrench in a timely manner after installing the saw blade, resulting in shaft deformation (this possibility also exists, not many)

4) The influencing factors of the board are: normally, when sawing melamine board, the resistance of the thick board (which is 2.5, 5CM thick) saw blade is relatively high, so it is necessary to adjust the saw blade lower to reduce shaking;